Wurths expanding foam cleaner 

• Removes fresh PU foam contamination without residue, e.g. on windows and doors
• Contains an additional spray head for external cleaning of foam guns and other surfaces.

Notice

Can etch surfaces such as lacquer, paint and plastics. Can cause colour fading or dissolving in textiles. Hardened PU foam can only be removed with PURLOGIC foam cleaner, art. no. 0892 160 000, or mechanically.

Instructions
First remove the black cap. Screw the PURlogic Clean can all the way into the gun support – do not screw too far or tilt. Let the cleaner take affect inside the gun for approx. 1 to 2 minutes; then let the cleaner drain out into a suitable container (e.g. carton) through the opening in the gun tip until the cleaner runs clear. If necessary, repeat this process two or three times. Once the cleaning process is complete, remove the gun from the cleaner can. The gun can then be stored depressurised.

To clean the exterior of the foam guns or other surfaces, clip the red spray head onto the can.