Stelmax 1985 Adhesive is an easily applied PVC resin and solvent based mix which bonds readily to form maintenance free joints of exceptional strength when used to bond both plasticised and rigid PVC and ABS. 1985 Adhesive is used extensively within the window industry for the installation of frames and attachments and is particularly suitable where bonding is only possible over small and narrow surface areas, When dry the product will exhibit weathering, UV and chemical resistance similar to that of a good quality rigid PVC.

1985 Adhesive is primarily available in both Clear and White

DIRECTIONS FOR USE

Ensure surfaces to which the adhesive is to be applied are clean and dry. Clean all areas with either Stelmax PVC Ultraclean or Thinners & Cleaning Fluid prior to application.

Remove the cap from the 1985 135gm tube, invert and pierce the sealed membrane, Attach the tapered applicator nozzle and trim the nozzle to the desired aperture using a sharp knife. Run a continuous thin film of adhesive to one surface only, bring both surfaces together immediately, and keep them under light pressure, When bonding very flexible material maintain pressure for a few seconds, extending to several minutes with rigid PVC, Adheres almost immediately on contact, although, the quantity applied, as well as the temperature and weather conditions will primarily determine the curing process at time of application.

Remove any excess material immediately with either Stelmax PVC Ultraclean or Thinners & Cleaning Fluid. To retain the product in a usable condition, seal the end of the nozzle with polythene or, alternatively, replace the tube cap after use and when the tube is empty.